Accessories for RC8W / RBDC8W :

The line cut-off is achieved by inserting a cut-off plug into the cut-off slots at the front of the terminating blocks. For each pair, it is possible to cut-off either both wires or just one, depending on the plug used.

The line tests are carried out by inserting the test plugs into the cut-off slots.

Accessories for RC5F / RC8F :

Line disconnection is obtained by inserting a disconnection plug (A) in slots located on the front part of the strips. It is possible to disconnect for each pair either both wires depending on the way the disconnection plug is inserted.

Line tests are performed by inserting test plugs (B) into the disconnection slot.

The fixation clamp (C) allows the assembly of strips on extrusion bars (two clamps per strip).

Lines can be protected individually by adding earthing clamps (D) and protection modules (E) on the RC5F strip. One earthing clamp allows to connect five protection modules.

Protection modules (E) are equipped with bipolar or tripolar 230V arresters. The test of the line can be done without removing the protection from the modules fitted with a test plug.